French-door and counter-depth Café refrigerators come with the usual GE-platform faults - evaporator fan motors, defrost heaters and thermistors that ice up the coil, and water inlet valves behind the dispenser. Ice makers in the door are the single most common call, and we replace the assembly or the fill tube heater depending on what has actually failed.
Café fridge repairCafé dishwashers share the GE tub and wash system. Drain pumps, circulation pumps, door latch switches and control boards make up most of what we replace. If the unit is filling but not washing, we test the wash motor and the turbidity sensor before condemning anything.
Café dishwasher repairCafé ranges and cooktops come in gas, electric and induction. On gas we see igniter and spark module faults and gas valves that need replacing, all handled under our Technical Safety BC gas licence. On induction it is usually a failed power module or a control board, and on radiant it is the surface element or its switch.
Café stove repairWall ovens and range ovens in the Café line fail on bake and broil elements, oven temperature sensors that drift and throw the calibration out, door hinges and latch motors, and the relay boards that switch the elements. If your oven is running hot or cold by fifty degrees, the sensor is the first thing we test.
Café oven repairOver-the-range and built-in Café microwaves need care on removal because of the trim kit and the cabinet. Door interlocks, magnetrons, high-voltage diodes and touch panels are the common failures. On the advantium and speed-oven models there is a halogen lamp circuit to check as well.
Café microwave repairCafé chimney and insert hoods fail on blower motors, control panels and lighting. We also get called when a new hood is moving far less air than expected, which on a condo install is usually the ducting or a blocked roof cap rather than the hood itself.
Café range hood repairCafé front-load and top-load washers see drain pump blockages, door lock assemblies, shift actuators on the top-load models and control boards. A machine that will not spin is usually the lock or the actuator rather than the motor.
Café washing machine repairCafé dryers, gas and electric, fail on heating elements or igniters, thermal fuses, drum rollers and belts. A dryer that runs but will not heat is the most common call and usually comes down to the element, the thermostat, or a vent that has not been cleaned. Gas models are handled under our Technical Safety BC licence.
Café dryer repair