G-series dishwashers are the Miele we see most. The usual calls are drain pump failure, a circulation pump that has gone noisy, water inlet valve faults and door springs or hinges that have stretched so the door drops. AutoDos models add a dispensing unit that can block. Hard water across the Lower Mainland is rough on the heater and the spray arm bearings, and we descale and test both as part of the job.
Learn more about our dishwasher repair services →W1 compact washers are 24 inches wide and stack with the dryer, which is why they are everywhere in Vancouver condos. Drain pump blockages, door lock failures, worn shock absorbers and heater faults make up most of what we see. We also get called for units that will not spin because the machine cannot balance a small load in a heavy cabinet.
Learn more about our washing machine repair services →T1 heat-pump dryers are ventless, so instead of a duct they have a condenser and a fine lint filter that both need clearing. When one comes in taking three hours to dry, a blocked heat exchanger is the first thing we check. Humidity sensors, the drain pump for the condensate and the compressor circuit are the other common faults.
Learn more about our dryer repair services →MasterCool built-in refrigeration is panel-ready and integrated into the cabinetry, so getting at it takes care. Evaporator fan failures, defrost faults that ice up the coil, faulty door seals on a heavy panelled door and control board problems are the usual causes. We handle the removal and refit rather than leaving you with a cabinet to sort out.
Learn more about our fridge repair services →Miele wall ovens and DGC steam ovens fail in fairly predictable ways: heating elements, door hinges that have gone slack, temperature sensors reading off, and on the steam models the water inlet and the descaling circuit. Pyrolytic self-clean cycles are hard on door seals and we replace those regularly.
Learn more about our oven repair services →KM induction cooktops are the common Miele cooking appliance in Vancouver. Touch controls that stop responding, a single zone that has dropped out, and induction modules that shut down on overheat are the three faults we see. On gas cooktops it is usually ignition or a blocked burner cap, and all gas work is done under our Technical Safety BC licence.
Learn more about our stove repair services →DA-series hoods are quiet units with electronic controls. Failed motors, blocked grease filters, control panels that no longer respond and burnt-out lighting are the standard calls. Where the hood is a recirculating insert in a condo we also check that the charcoal filter has actually been changed.
Learn more about our range hood repair services →Miele built-in microwaves and speed ovens are installed flush in a cabinet run. Door interlock switches, magnetrons, and control boards are the common failures. Removal and refit are part of the job on a built-in and we do that without damaging the surrounding cabinetry.
Learn more about our microwave repair services →